Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K806 Engine - K1607 Engine - K16 with VVC08 Engine - L Series09 Emission control10 Engine management system - MEMS11 Engine management system - EDC12 Fuel delivery system13 Cooling system - K Series14 Cooling system - L Series15 Manifold & exhaust systems16 Clutch17 Manual gearbox - R6518 Manual gearbox - PG119 Automatic gearbox - CVT20 Automatic gearbox21 Drive shafts22 Steering23 Front suspension24 Rear suspension25 Brakes26 Restraint systems27 Body28 Heating & ventilation29 Air conditioning30 Wipers & washers31 Electrical32 Instruments
Rover 200 Workshop Manual (1995-1999)04 · Maintenance
04 · Maintenance

Steering

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Maintenance › Steering
MaintenanceSteering

STEERING

Check and top-up power steering fluid

Carry out fluid level check when engine is stopped and system is cold.

NOTE: It is essential that power steering system should not have been operated since engine was stopped.

Check and top-up power steering fluid – Carry out fluid level check when engine is stopped and system is cold.
  1. Clean reservoir around filler cap and level indicators.
  2. Visually check fluid level is between level indicators.
  3. If required, remove filler cap and top-up with DEXRON II D specification fluid. Do not overfill.

CAUTION: Ensure no dirt is allowed to enter reservoir when cap is removed.

  1. Refit filler cap.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.