Model: ’T’ Series Year: 1995 on
- Make
- Rover
- Model
- 400 Workshop Manual
- Year
- 1995–2000
- Section
- Engine tuning data › Model: ’T’ Series Year: 1995 on
InformationModel: ’T’ Series Year: 1995 on
Model: ’T’ Series Year: 1995 on
Engine3
| Type/Capacity: | T16/1994 cm |
| Firing order | 1-3-4-2 |
| Compression ratio: | 10.0 : 1 |
| Idle speed controlled by ECM | 850 ± 25 rev/min |
| Exhaust gas CO content at idle | less than 0.5% hot |
| Ignition timing at idle speed:* | |
| Vacuum connected | 12 ± 5° BTDC |
Ignition Coil
| Type | Quad output |
| Part No | NEC 100710 |
| Primary resistance at 20°C | 0.41 to 0.61 ohm |
Spark Plugs
| Type | Unipart GSP 6662 |
| Gap | 0.85 mm |
Electronic Fuel Injection
| Type | Indirect multi-port injection |
| MEMS - ECM | |
| Without cruise control | MKC 103310 |
| With cruise control | MKC 102320 |
| Injectors | MJY 100460 |
| Fuel pump | WFX 100630 |
| Fuel pressure regulator | MKW 10016 |
| Fuel pressure | 3.0 bar (above inlet manifold pressure) |
| Throttle position sensor voltage: | |
| Throttle closed | 0 to 1 V |
| Throttle open | 4 to 5 V |
| Air temperature sensor | NNK 10001 |
| Coolant temperature sensor | ADU 7161 |
| Heated oxygen sensor | MHK 10004 |
| Fuel grade | 95 RON minimum - UNLEADED fuel |
CAUTION: Serious damage to the engine may occur if a lower octane number fuel than recommended is used. Serious damage to the catalyst will occur if LEADED fuel is used.
* Ignition timing in Crankshaft degrees.
Parts & tools for this job For 1995 Rover 400
- PARTEngine gasket setSearch: Rover 400 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.