Engine - ’k’ series
- Make
- Rover
- Model
- 400 Workshop Manual
- Year
- 1995–2000
- Section
- Torque wrench settings › Engine - ’k’ series
InformationEngine - ’k’ series
Refer to appropriate section heading for component torque figures, e.g. Road wheel nuts - refer to SUSPENSION Exhaust front pipe to manifold - refer to MANIFOLD AND EXHAUST
ENGINE - ’K’ SERIES
| Timing belt top cover bolts | 5 Nm |
| Tensioner pulley backplate bolt - Manual | |
| timing belt tensioner | 10 Nm |
| Timing belt lower cover bolts | 9 Nm |
| Drive belt tensioner to steering pump bracket | 25 Nm |
| Crankshaft pulley bolt | 205 Nm |
| Engine RH mounting to engine nuts | 100 Nm |
| Engine RH mounting to body through bolt | 75 Nm |
| Torque mounting RH bracket to engine bolts | 60 Nm |
| Oil pressure switch | 12 Nm |
| Camshaft gear bolt: | |
| M8 bolt | 35 Nm |
| M10 bolt | 65 Nm |
| Timing belt tensioner pulley Allen bolt - Manual | |
| timing belt tensioner | 45 Nm |
| Timing belt tensioner bolt - Automatic2 | |
| timing belt tensioner | 25 Nm |
| Cover plate - rear camshaft bolts | 25 Nm |
| Cylinder head bolts, tighten progressively:1 | |
| 1st stage1 | 20 Nm |
| 2nd stage1 | 180° |
| 3rd stage | 180° |
| Camshaft timing belt rear cover bolts | 9 Nm |
| Alternator top mounting bracket nut1 | 25 Nm |
| Camshaft cover to carrier bolts | 10 Nm |
| Spark plug cover screws | 2 Nm |
| Engine sump drain plug | 42 Nm |
| Engine lifting bracket bolts12 | 9 Nm |
| Oil pump bolts | 10 Nm |
| Harness to oil pump bolts12 | 10 Nm |
| Engine sump bolts: | |
| M6/M8 | 10 Nm |
1Tighten in sequence
2New Patchlok bolt must be fitted
Parts & tools for this job For 1995 Rover 400
- PARTEngine gasket setSearch: Rover 400 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.