Engine - ’d’ series
- Make
- Rover
- Model
- 400 Workshop Manual
- Year
- 1995–2000
- Section
- Torque wrench settings › Engine - ’d’ series
InformationEngine - ’d’ series
ENGINE - ’D’ SERIES
| Tappet adjusting screws locknut | 14 Nm |
| Timing belt adjuster bolts | 44 Nm |
| Timing belt cover bolts | 10 Nm |
| Engine LH mounting to engine bolt and nuts | 50 Nm |
| Engine LH mounting through bolt | 74 Nm |
| Steering pump mounting bracket bolts | 44 Nm |
| Earth lead to camshaft cover stud nut | 10 Nm |
| Crankshaft pulley bolt: | |
| Engine type D16Y3 | 165 Nm |
| Engine type D16B2 | 20 Nm + 90° |
| Engine sump bolts1 | 1 14 Nm |
| Anti-beaming bracket to engine bolts1 | 24 Nm |
| Anti-beaming bracket to gearbox bolts | 44 Nm |
| Engine LH front mounting to engine bolts | 54 Nm |
| Engine LH front mounting to body bolts | 44 Nm |
| Engine RH front mounting to engine bolts | 64 Nm |
| Engine RH front mounting to body bolts | 44 Nm |
| Engine RH front mounting bracket nut | 60 Nm |
| Engine rear mounting to rear beam bolts | 65 Nm |
| Engine rear mounting bracket to engine bolts | 83 Nm |
| Engine rear mounting through bolt | 74 Nm |
| Exhaust manifold support bracket bolts | 24 Nm |
| Engine LH mounting to body bolt and nuts | 52 Nm |
| Engine LH mounting through bolt | 74 Nm |
| Engine RH mounting to engine nuts | 64 Nm |
| Cylinder head bolts, tighten progressively:1 | |
| 1st stage1 | 30 Nm |
| 2nd stage | 65 Nm |
| Alternator bracket to cylinder head bolt | 44 Nm |
| Drive plate to crankshaft bolts | 74 Nm |
| Oil pressure switch | 18 Nm |
| Distributor to cylinder head bolts | 24 Nm |
1Tighten in sequence
Parts & tools for this job For 1995 Rover 400
- PARTEngine gasket setSearch: Rover 400 1995 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.