Torque wrench settings
- Make
- Rover
- Model
- 600 620 Diesel Repair Manual Supplement
- Year
- 1995–1999
- Section
- Data, torque & tools › Torque wrench settings
Manual gearboxTorque wrench settings
TORQUE WRENCH SETTINGS
| Gear lever to slector shaft nut | 25 Nm |
| Lower suspension arm ball joint castle nut | 50 Nm* |
| Damper fork pinch bolt | 44 Nm** |
| Damper fork to lower arm nut | 65 Nm |
| Gearcase to differential housing, bolt | 25 Nm |
| Gearbox to adaptor plate, bolts | 70 Nm |
| Engine mounting bracket to gearbox, bolts | 45 Nm |
| LH engine mounting: | |
| M10 nuts | 45 Nm |
| M12 nut | 70 Nm |
| Centre beam bolts | 50 Nm |
| Speed sensor bolt | 19 Nm |
| Slave cylinder bolts | 22 Nm |
| LH radius rod to lower arm bolts | 105 Nm |
| RH radius rod to lower arm bolts | 105 Nm |
| Radius rod to front beam, nuts | 68 Nm |
| Gear change steady bar bolt | 60 Nm |
| Road wheel nuts | 110 Nm |
| Crank sensor bracket nut | 8 Nm |
* Align to slot in nut - Do Not slacken ** Full weight of engine must be on mounting before tightening nut
SERVICE TOOLS
18G 1707 Ball Joint Seperator 18G 1578 Drive Shaft Seperator 18G 1354-16 Differential Oil Seal Replacer
Parts & tools for this job For 1995 Rover 600
- PARTClutch kitSearch: Rover 600 1995 clutch kit
- TOOLClutch alignment toolSearch: clutch alignment tool
- FLUIDGear oilSearch: Rover 600 manual gearbox oil
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.