Gearbox (page 7 of 7)

40. Repeat above operations and fit RH drive shaft.
41. Position steady bar and selector rod, align holes.
42. Fit selector rod roll pin; fit retaining clip.
43. Insert steady bar washers, fit bolt and tighten to 60 Nm.
44. Position slave cylinder to gearbox; fit bolts and tighten to 22 Nm.
45. Clean push rod and fit to slave cylinder
46. Lubricate clevis pin and fit to push rod and release lever, retain with washer and ’R’ clip.
47. Fit centre beam; tighten bolts to 50 Nm.
48. Fill gearbox with correct quantity and grade of oil. See MAINTENANCE.
49. Fit front under belly panel, tighten bolts.
50. Fit front under belly panel scrivet fixings.
51. Fit LH under belly panel. See BODY, Repairs.
52. Fit road wheel(s) and tighten nuts to correct torque. See INFORMATION, Torque wrench settings.

NOTE: Before fitting the wheels, clean mating surface of brake disc and inside of wheel.

53. Remove stand(s) and lower vehicle.
54. Tighten damper pinch bolt to 44 Nm and damper fork nut to 65 Nm.
55. Connect battery earth lead.
56. Check front wheel alignment, adjust if necessary. See REPAIR MANUAL - FRONT SUSPENSION - Repairs.