9-5 Linear (9600) L4-2.3L Turbo (2.3t) (2004)
/l4-2.3l_turbo_(2.3t)/Page-3979011.png)
4. If there is no old adhesive, or if the adhesive is not intact, primer must be applied to the surfaces with which the adhesive will be in contact. Use
Betaprime 5061 (green cap) on any touched-up surfaces. Do not use body primer on old, well-cohered adhesive.
5. Fit the lifting handle on the outside of the windscreen and place the windscreen inside up on a stand to provide an appropriate work height.
6. Press on the decor strip on the upper edge of the windscreen. The decor strip must extend the same amount at each end. Avoid touching the primed
surface.
7. Carefully wash the edges of the window with Betawipe 3300. Carefully wipe the edges using the wet cleaning cloth. Dry with the dry cleaning
cloth provided in the adhesive kit. Avoid touching the cleaned surface.
IMPORTANT: Do not allow the cleaning agent to dry naturally as it may leave traces of grease on the glass. Always dry with clean,
lint-free rags and refold them frequently.
8. Apply Betaprime 5061 (green cap) to the cleaned surface. Allow the primer to dry for 10 minutes.
NOTE: If the windscreen is to be secured with tape after being fitted, make sure the roof has been cleaned before starting to fit the windscreen.
9. Apply the adhesive as follows:
-
Clip off the tip of the adhesive cartridge nozzle so as to provide a suitable shape to the bead of adhesive.
-
Hold the gun at right angles to the window. Start at the lower edge of the window and apply a bead of adhesive to the primed surface along the
retainer strip. Make sure that there are no breaks in the adhesive bead.
IMPORTANT: The adhesive starts to cure as soon as the contents of the two tubes is mixed. Fit the window glass within 5 minutes of