LW2 V6-3.0L VIN R (2000)
NOTE: Use only mineral oil to lubricate O-ring seals. Use of PAG oil will cause premature corrosion of joints.
3. Remove shipping caps from thermal expansion valve (TXV) and suction/liquid line assembly.
4. Lubricate suction/liquid line assembly to TXV 0 - rings.
5. Position suction/liquid line assembly to TXV and hand start bolt.
Torque: 7 N.m (62 in-lbs)
6. Remove shipping cap from suction/liquid line assembly and from liquid line.
7. Add any PAG oil that was removed during recovery to liquid line.
IMPORTANT: Always install new seal washers to reduce refrigerant leaks.
8. Install seal washer and install suction/liquid line assembly to liquid line and hand start nut.
Torque: 12 N.m (106 in-lbs)