LW2 V6-3.0L VIN R (2000)
7. Remove SIR coil assembly rosebud-type fastener from bracket below steering column.
8. Disconnect horn/cruise connector under steering column.
9. Remove coil assembly by carefully prying the plastic retainers.
10. Guide coil wiring harness from behind lever control switch and remove SIR coil assembly.
INSTALLATION
NOTE: A new coil assembly is equipped with a yellow tab that is removed after steering wheel is installed. This tab passes through the steering wheel.
1. Route SIR wiring harness and horn/cruise connector behind turn signal lever combination switch and down steering column.
2. Install coil assembly to turn signal lever combination switch housing.
3. Install upper and lower steering column trim covers.
Torque: 4 N.m (35 in-lbs)