LW2 V6-3.0L VIN R (2000)
5. Install Steering Wheel Puller (J1859-A and J-42578 or equivalent).
NOTE: Always align the front wheels to the straight ahead position when removing or installing a coil assembly.
If a coil is removed without the wheels in the straight ahead position, the same coil may be installed if the steering shaft and coil hub have not rotated.
6. Remove steering wheel while feeding wiring through wheel opening.
NOTE: If yellow tab is not available, use tape to prevent coil from rotating.
7. Insert yellow tab or use a piece of tape to prevent coil assembly from rotating.
INSTALLATION
1. Remove yellow tab or tape from SIR Coil assembly.
2. Route wiring through steering wheel and install steering wheel onto steering shaft noting orientation notch that locates steering wheel in correct
position.
IMPORTANT: A new steering wheel attachment nut must be used.
3. Install new steering wheel attachment nut.
Torque: 40 N.m (30 ft-lbs)