SW1 L4-1.9L SOHC VIN 8 (1996)
3.
Clean sunroof module with isopropyl alcohol, at locations where felt pads will be applied. (One felt pad is applied to rear top of each sunroof
guide, one felt pad is applied to each side of the sunroof rear cross beam above where sunshade double stiffening ribs are located, and one felt pad
is applied to the center of the rear cross beam. Refer to illustration.)
4.
Apply felt pads, contained in Felt Pad Kit (P/N 21056020), to sunroof module at the following locations:
a.
Slide sunroof sunshade to the closed position.
b.
Remove backing from felt pad and place it on the end of a putty knife with adhesive side facing up.