SW1 L4-1.9L SOHC VIN 8 (1996)
NOTICE:
Care should be taken in the next step to prevent bending the rear beam.
16.
From the felt pad kit (P/N 21056020), cut the two larger felt patches in half, and using a straight screwdriver at the ends of rear beam, create
clearance between rear beam and side rails with light downward pressure. Insert felt patches between rear beam and side rails, one on each side.
17.
Cycle sunroof into Vent, Full Open, and Full Closed positions to verify proper operation.
18.
Install headliner. (Refer to "Headliner" installation procedures in the "Vehicle Interior Systems" section of the appropriate year "Body/Repair
Service Manual.")
Condition 4
Condition 4: Sunshade contacting rear drain channel in center.
Models affected:
^
1997 Coupes built before and including VIN VZ358909
^
1996-1998 Sedans
1.
Remove headliner. (Refer to "Headliner" removal procedures in the "Vehicle Interior Systems" section of the appropriate year "Body/Repair
Service Manual.")
2.
Open sunroof to vent position.
