SW1 L4-1.9L SOHC VIN 8 (1996)
12.
Back off each fastener one complete turn. Then align sunroof module by cycling sunroof glass open and closed. (In the closed position, the
sunroof glass will center the sunroof module.)
13.
With sunroof glass fully closed, tighten sunroof module fasteners.
Torque: 14 N.m (124 in-lbs)
14.
Inspect for correct routing of black plastic sunroof tubing. The black plastic sunroof tubing should be on the bottom side of the copper drive cables
as shown in illustration.
NOTICE:
Make sure not to crush plastic tubing when routing plastic tubing. If wire ties are installed too tightly, the drive cable cannot move freely inside
plastic tubing, causing the sunroof to bind or become inoperative.
15.
Inspect the four tab locations where the rear channels meet the rear beam to make sure the tabs are bent upward.
IMPORTANT:
Care should be taken to prevent scratching the paint. If the surface of the tabs becomes scratched, refer to "Corrosion Repairs" in the appropriate year
"Body/Repair Service Manual."
^
If tabs are not bent upward, insert a straight screwdriver (covered with a cloth or electrical tape to prevent scratching) into the four tab locations and
pry upward.
^
If tabs are bent upward, proceed to next step.
