SW1 L4-1.9L SOHC VIN 8 (1996)
2. Using three screws, install sunroof motor and connect motor harness to motor.
Torque: 3-4 Nm (27.35 in-lbs)
3. Install sunroof switch/console assembly
4. Install headliner as outlined in "Headliner Installation" procedure.
SUNROOF MOTOR TO MODULE TIMING - SEDAN
NOTICE: The Sedan sunroof motor has an internal microswitch which opens the motor circuit (turns motor off) when the glass reaches the full
vent position. If a technician removes the sunroof motor from the module and then functions the motor or changes the position of the sunroof glass
while the motor is removed from the module, the timing of the sunroof motor to sunroof module will be out of phase. Putting the motor back into
the module while out of phase will cause the loss of the vent position. It is important that the technician use proper diagnostic procedures to avoid
unnecessary bench testing of the motor or running the motor while the motor is hanging loose in the vehicle during sunroof diagnostics. If the
motor and module become out of phase, re-time the motor using the following procedure.
REMOVAL
1. Remove sunroof motor with the jumper harness from vehicle.
2. Backprobing with an ohmmeter, connect meter leads between white and yellow wires located at the gear housing portion of the motor.
3. Insert a large flat bladed screwdriver into motor gear drive slot. Rotate the sunroof motor gear drive counterclockwise until the ohmmeter reads
OPEN CIRCUIT This positions the gear drive to FULL VENT
NOTICE: It may take up to eleven rotations to reach the OPEN CIRCUIT position.
4. Continue to turn the motor gear drive exactly 1 1/2 additional turns counterclockwise. This will re-time the motor to the fully closed position.
Make sure the sunroof glass is in fully closed position, then reinstall motor as outlined in "Sunroof Motor-Sedan Removal" procedure.
