tC L4-2.4L (2AZ-FE) (2005)
d. Remove the 8 bolts and 2 nuts, then remove the cylinder head cover.
16. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
a. Lift the engine upward using the transmission jack, then remove the bolt and nut shown in the illustration.
NOTICE: Do not lift the engine more than necessary.
b. Remove the V-ribbed belt tensioner.
17. REMOVE CRANKSHAFT POSITION SENSOR
18. REMOVE OIL PAN SUB-ASSEMBLY
a. Install the engine hanger No. 1 and No. 2 with the bolts as shown in the illustration.
Torque: 38 Nm (387 kgf-cm, 28 ft. lbs.)
Parts No.
b. Using a chain block and sling device, hold the engine.