tC L4-2.4L (2AZ-FE) (2005)
/Page-332009.png)
c. Remove the 12 bolts and 2 nuts.
d. Insert the blade of SST between the crankcase, chain cover and oil pan, then cut off the applied sealer and remove the oil pan.
SST 09032-00100
NOTICE: Be careful not to damage the contact surface of the crankcase, chain cover and oil pan.
19. SET NO. 1 CYLINDER TO TDC/COMPRESSION
a. Turn the crankshaft pulley until its groove and the timing mark "0" of the timing chain cover are aligned.
b. Check that each timing mark of the camshaft timing gears is aligned with each timing mark located on the No. 1 and No. 2 bearing caps as
shown in the illustration.
If not, turn the crankshaft by 1 revolution (360°) to align the timing marks as above.
20. REMOVE CRANKSHAFT PULLEY
a. Using SST, fix the pulley and loosen the pulley bolt.
SST 09213-54015 (91651-60855), 09330-00021
b. Using SST and the pulley bolt, remove the crankshaft pulley.
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
