xD L4-1.8L (2ZR-FE) (2008)
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(d) Reconnect the PNP switch connector.
(e) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
6. CHECK HARNESS AND CONNECTOR (CLUTCH START SWITCH OR PNP SWITCH - ECM - ST RELAY)
(a) Check the harness and connector (for automatic transaxle models).
(1) Remove the ST relay from the engine room relay block.
(2) Disconnect the Park/Neutral Position (PNP) switch connector.
(3) Disconnect the ECM connector.
(4) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
(5) Reinstall the ST relay.
(6) Reconnect the park/neutral position switch connector.
(7) Reconnect the ECM connector.