xD L4-1.8L (2ZR-FE) (2008)
(b) Check the harness and connector (for manual transaxle models).
(1) Remove the ST relay from the engine room relay block.
(2) Disconnect the clutch start switch connector.
(3) Disconnect the ECM connector.
(4) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
(5) Reinstall the ST relay.
(6) Reconnect the clutch start switch connector.
(7) Reconnect the ECM connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPAIR OR REPLACE STARTER CIRCUIT (STARTER - ST RELAY)
7. INSPECT IGNITION SWITCH
(a) Remove the ignition switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
(c) Reinstall the ignition switch.