xD L4-1.8L (2ZR-FE) (2008)
(b) Place matchmarks on the sliding yoke of the steering intermediate shaft assembly and the power steering.
(c) Loosen bolt A, remove bolt B and separate the steering intermediate shaft assembly.
14. REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
(a) Remove clip A, separate clip B from the body and separate steering column hole cover No. 1.
NOTE: Do not damage clip B.
15. REMOVE FRONT WHEEL
16. SEPARATE TIE ROD END SUB-ASSEMBLY LH
17. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT: Use the same procedure for the RH side as for the LH side.
18. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
19. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT: Use the same procedure for the RH side as for the LH side.
20. REMOVE FRONT SUSPENSION LOWER ARM LH
21. REMOVE FRONT SUSPENSION LOWER ARM RH
HINT: Use the same procedure for the RH side as for the LH side.
22. SUSPEND ENGINE ASSEMBLY (for 2ZR-FE)
(a) Remove the bolt and remove the wire harness clamp bracket.
(b) Install the engine hanger with the bolt in the position shown in the illustration.
Part No.:
No. 1 engine hanger
12281-37020
No. 2 engine hanger
12282-37010
Bolt
91552-81050
Torque: 43 Nm (439 kgf-cm, 32 ft-lbf)