seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Slide box (vehicles from 07.00): removing and installing > < Slide box: removing and installing

Leon Mk1

Slide box (vehicles up to 06.00): removing and installing
   
Slide box (vehicles up to 06.00): removing and installing
Vehicles from 07.00 onwards → Chapter
Notes to consider before removing the slide box → Chapter
1 - Sealing screw
q   15 Nm
q   Always renew the seal → Fig.
q   ATF level: checking and topping up → Chapter
2 - O-ring
q   Always renew
3 - Solenoid valve -N90-
q   Grey
q   Identification → Fig.
4 - O-ring
q   Always renew
5 - O-ring
q   Always renew
6 - Solenoid valve -N93-
q   Pink
q   Identification → Fig.
7 - O-ring
q   Always renew
8 - Solenoid valve -N91-
q   Blue
q   Identification → Fig.
9 - Support
q   For the solenoid valves
10 - Nut
q   9 Nm
11 - O-ring
q   Always renew
12 - Solenoid valve -N89-
q   Yellow
q   Identification → Fig.
13 - Solenoid valve -N88-
q   Green
q   Identification → Fig.
14 - O-ring
q   Always renew
15 - Bolt
q   8 Nm
16 - Slide box
q   Dismantling and fitting → Chapter, Planet gears: dismantling and assembling
q   Identification → Fig.
17 - Manual slide
q   Secure so that it does not come out when removing the slide box
18 - Wiring harness
q   For the solenoid valves
19 - O-ring
q   Always renew
q   For the wiring harness connector
20 - Connector
q   For the wiring harness
q   Remove → Chapter, Planet gears: dismantling and assembling
q   Engage on fitting to the gearbox casing
21 - O-ring
q   Always renew
q   Dismantling and fitting → Chapter, Planet gears: dismantling and assembling
22 - Gearbox casing
23 - Bolt
q   9 Nm
24 - ATF strainer
q   To replace, it is necessary to remove the sump and fit it again
25 - Magnet
q   Fit to the sump filler neck
26 - Overflow pipe
q   Remove to let the ATF come out → Chapter, ATF level: checking and filling; Changing ATF
27 - Bolt
q   8 Nm
28 - Sump
q   Assembly procedure → Chapter, Planet gears: dismantling and assembling

   
Renew the plug oil seal
–  Cut the seal -arrow- with a pair of cutting pliers, always renew the seal.
–  After the repairs, fit the plug by hand with a new o-ring and fill with ATF.º
–  Fill with ATF, check ATF level and top up → Chapter.
  N38-0037
Identification of the slide box
The code is stamped on a plate -arrow-, which should always be assigned to its corresponding slide box.
  N38-0111
Identification of the solenoid valves
A - Solenoid valve -N88- (green)
B - Solenoid valve -N89- (yellow)
C - Solenoid valve -N90- (grey)
D - Solenoid valve -N91- (blue)
E - Solenoid valve -N93- (pink)
1 - Nut for securing the solenoid valves. Tightening torque 9 Nm
  N38-0116

Slide box (vehicles from 07.00): removing and installing > < Slide box: removing and installing