SEAT Workshop Service and Repair Manuals

Gear drive mechanism: adjustment Special tools and workshop equipment required

t  Gear lever feeler gauge pin -T10027-   Note! t  In order to adjust the gearbox driver correctly, it is necessary to take the following points into account: t  Gearbox actioning elements and actioning mechanism transmission in perfect working order. t  The gearbox action must be smooth, with no harshness. t  The gearbox, the clutch driver and the clutch, must be in perfect condition. l  Gearbox in neutral

–  Pull the safety mechanism of the connection and selection cables forwards -arrow 1-, to the limit, block it, then turn to the left -arrow 2- and separate the cables of the attachments.

Attach the selector rod as described below: –  Push the selector rod downwards -arrow 1-. –  When pushing the selector rod, turn the bend -A- in the direction of -arrow 2- until the rod is blocked. –  Remove the dust cover from the centre console frame cover and turn over.

Attach the gear stick as follows: –  Put the gear lever in neutral. –  Insert the -T10027- pin in aperture -B- through aperture -A-.   Note! In order to make it easier to place the -T10027- tool, move the gear lever until it faces the two apertures.

–  Turn the gear selection and connection cable safety mechanism to the right (in the direction of the arrows), as far as it will go. The spring pushes the safety mechanism to the initial position.

–  Turn the bend -A- in the -direction of the arrow-, until it is back in its original position.

–  Now it must be possible to move the selector rod in the -direction of the arrow-.

–  Withdraw the -T10027- pin from apertures -A- and -B- and position the dust cover on the frame.