Leon Mk1
|
|
|
1 - | Gearbox casing |
q | If replaced, adjust differential → Chapter |
2 - | Adjustment sleeve |
q | 2 units |
3 - | Bush |
q | Gearbox breather |
q | Remove with pliers |
q | Fit as far as it will go |
4 - | Cap |
q | For gearbox breather |
5 - | Reversing light switch |
q | 20 Nm |
6 - | Gear selector shaft |
q | Removing and installing → Fig. |
7 - | Stop cap |
8 - | Compression spring |
9 - | Support plate |
q | Hold the washer on removing the circlip, → Item. Then stretch the compression spring carefully, → Item |
10 - | Safety ring |
q | Always renew |
11 - | Needle roller bearing |
q | For layshaft |
q | Remove → Fig. |
q | Fit → Fig. |
12 - | Ball bearing bush |
q | For gear selector shaft |
q | Remove → Fig. |
q | Fit → Fig. |
13 - | Oil seal |
q | For gear selector shaft |
q | Can be replaced with the gearbox in place |
q | Remove → Fig. |
q | Fit → Fig. |
14 - | Outer track, roller bearing |
q | For differential |
q | Removing and fitting → Chapter |
q | If replaced, adjust differential → Chapter |
15 - | Shim S1 |
16 - | Locking nut for gear selector shaft |
q | 40 Nm |
17 - | Articulation flange oilseal |
q | Renew → Chapter |
|
|
|
|
|
|