Leon Mk1
Reverse gear shaft - Assembly overview |
1 - | clutch housing |
2 - | Axial/radial needle bearing |
q | removing → Fig. |
q | After installation, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig.. |
3 - | Gear of reverse gear |
4 - | Circlip |
q | Use pliers -A 81124- to remove the safety ring. |
q | Always replace. |
5 - | Reverse gear mobile pinion |
q | Installation position: the pinion collar must face pinion of reverse gear |
6 - | Reverse gear shaft: |
q | removing → Chapter |
7 - | Axial/radial needle bearing |
q | removing → Fig. |
q | After removal, the axial/radial needle bearing must always be replaced. |
q | Installing → Fig.. |
8 - | Support for reverse gear shaft |