seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
5th gear: Disassembling and assembling > < Reverse gear shaft - Assembly overview

Leon Mk1

Reverse gear shaft: disassembly and assembly
Reverse gear shaft: disassembly and assembly
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  Extractor kit -T20140-, see equivalent → Anchor
t  Extractor kit -U 40100B-, see equivalent → Anchor
t  Kit (case) -U 40200A-, see equivalent → Anchor
t  Kit (case) -U 40300-, see equivalent → Anchor

   
Remove the support axial/radial needle bearing of the clutch housing
–  Locate adapter -T20140/14- on axial/radial bearing.
–  Place adapter -T20140/1- on clutch casing and screw extractor shaft into adapter -T20140/14- until claws expand.
–  Work nut -1- until outer track of small roller bearing is extracted.
  Note
Release the claws and then expand again after the outer ring has been pulled out by approx.1 mm so that it sits completely on the base of the bearing.
  E35-0187
Install the support axial/radial needle bearing of the clutch housing
  E35-0044
Remove the support axial/radial needle bearing of the reverse gear shaft support
  E35-0045
Install the support axial/radial needle bearing of the reverse gear shaft support
  E35-0046

5th gear: Disassembling and assembling > < Reverse gear shaft - Assembly overview