Clutch action: Repairs

Make

SEAT

Model

Leon Mk1

Section

02R, 5-speed manual transmission › Clutch, control › Clutch action: Repairs

Power transmissionClutch action: Repairs

Installing –  Fit the pedal assembly and clutch pump into the dash panel base and tighten the new bolts to the torque of 25 Nm. –  Place clutch pedal switch -F36- in mounting and turn 45° to right. –  Plug in the connector of the clutch pedal switch -F36 -. –  Fit the crash strap of the clutch pedal and tighten the fastening bolt to a torque of 20 Nm. –  Install footwell cover on driver side → body - inner assembly work; Rep. gr. 68 .

Vehicles with start/stop system: –  Insert the clutch position sender -G476- up to the end of the master cylinder when the connector is closed. l  Clutch position sender must clip in -arrow A-. –  To check, pull on clutch position sender-arrow B-. Continued for all vehicles

–  Remove from the clutch master cylinder the hydraulic circuit clamp (male) -SAT 1211-and the hydraulic circuit clamp (female)from the pipe and hose assembley -SAT 1210-. –  Press pipe and hose lines -C- with new sealing ring into mount on master cylinder until retaining clip -B- arrests audibly. –  Detach the hose clamp -U 30042- from the hose trailing -A-. –  After fitting the pedal assembly and the clutch pump, the clutch system must be bled of air → Chapter. –  Install air cleaner housing → Rep. gr.23. –  With the ignition switched off, connect battery earth strap.

01 Transmission

The same page in: Leon Mk2.