Leon Mk1
Selector forks - exploded view |
Note
It is not necessary to dismantle the gearbox prong unit → Item to remove and assemble the gearbox selector rods, the fastening washers and the ball bearings. |
1 - | Selector fork cluster with selector plates |
2 - | 3rd / 4th gear selector pin |
q | After assembly, it should still be possible to turn slightly |
q | Identification → Fig. |
q | Several manual gearboxes have individual selector pins → Fig. |
q | Identification → Fig. |
3 - | Ball bearing |
q | Remove → Fig. |
q | Driving in → Fig. |
4 - | Securing washer |
q | Always replace. |
q | Removing → Fig. |
q | Installing → Fig. |
5 - | 1st / 2nd gear selector pin |
q | Identification → Fig. |
q | Following the installation of the securing washers, the pins should move freely |
6 - | 5th gear selector fork with selector pin |
q | The gear selection can not be separated from the prong |
q | Identification → Fig. |
7 - | Bearing pin |
q | For the selector fork of 5th gear |