| –
| Loosen oil level test bolt -arrow-. |
Note | t
| Oil level is correct when the oil reaches the bottom edge of filling hole. |
| t
| The type of bolt depends on the material used to make the gearbox; this may be magnesium or aluminium . Allocation of the corresponding bolt → Spare parts catalogue. |
| –
| If the oil level is not correct, complete oil level. |
| –
| Unscrew control lid, start engine and let the gears work with engaged gear for about 2 minutes. |
| –
| Stop the engine, remove oil cap and check level again, top up if necessary. |
| –
| Tighten the gearbox oil level control cap to a torque of 25 Nm. |
| –
| Remove the left soundproofing. . |
| –
| Install the medium soundproofing and the left front wheel. |
|
|
|
