Leon Mk1
| Selector forks - exploded view |
Note| t | The base strips of the gear change forks have been machined (drilled) together. If any element must be replaced then the entire mechanism must be replaced together. |
| t | Do not mix up the base strip for 1st/2nd gear → Item with that of 3rd/4th gear → Item |
| 1 - | 3rd/4th gear prong |
| 2 - | Ball bearing |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 3 - | Securing washer |
| q | Always replace. |
| q | Removing → Fig. |
| q | Installing → Fig.. |
| 4 - | Securing washer |
| 5 - | Glass |
| 6 - | Gearbox selector bolt |
| q | Identification → Fig. |
| q | Following the installation of the securing washers, the pins should move freely |
| 7 - | Gearbox selector bolt |
| q | Identification → Fig. |
| q | Following the installation of the securing washers, the pins should move freely |
| 8 - | 5th gear base strip |
| 9 - | 3rd/4th gear base strip |
| 10 - | 3rd/4th gear base strip |
| 11 - | Reverse gear base strip |
| 12 - | Bolt |
| 13 - | Reverse gear prong |
| 14 - | Reverse gear securing element |
| 15 - | Securing washer |
| 16 - | 1st/2nd gear prong |
| 17 - | Gearbox selector bolt |
| q | Identification → Fig. |
| q | Following the installation of the securing washers, the pins should move freely |
| 18 - | 5th gear prong |
| 19 - | Gearbox selector bolt |
| q | Identification → Fig. |
| q | Following the installation of the securing washers, the pins should move freely |
| 20 - | Support bolt |
| q | For the 5th gear prong |