To fit, slide the mobile sleeve onto the synchromesh.
l
Installation position: the thinnest grooves -arrow C- of the synchromesh locking elements are aligned with the grooves -arrow D- of the mobile sleeve.
–
Fit the locking elements in the deepest grooves -arrows- and fit the springs off-set by 120º. The protruding end of the spring should enter into the hollow locking element.
–
Insert the end ring on the guide socket -T20132-.
–
Insert the stop / end ring along with the guide socket -T20132- onto the 5th gear synchromesh and mobile sleeve (note the installation position → Chapter).
l
The hooks -arrow 1- should be inserted in the grooves -arrow 2- of the synchromesh locking elements.
–
Press the stop ring down until the hooks are inserted.