SEAT Workshop Service and Repair Manuals > Leon Mk1 > 09G automatic gearbox | Automatic gearbox, control, assembly, housing | Automatic gearbox: check the ATF level

ATF level: check

Check the tool and equipment equivalence table according to the applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Tray -T20173-, see equivalent → Anchor

t	Central diagnosis -VAS 505X-

–	Switch off engine

Note

On starting the test, the temperature of the ATF should not exceed approx 30° C.

l	The gearbox should not have the emergency function activated, the temperature of the ATF should not exceed approx 30° C.

l	The vehicle should be in a horizontal position.

l	Selector lever must be in position “P”.

Connect the equipment and continue until it is ready to function

–	Select Guided functions in the right hand margin.

–	Next select vehicle, gearbox and Check ATF level.

–	Press the→ key.

–	Start the engine.

–	Raise the vehicle.

–	Fit tray -T20173- beneath gearbox.

–	Press the→ key.

When the temperature displayed is between 35°C and 45°C:

–	Remove the ATF level test plug located in the oil sump.

The ATF left in the overflow tube comes out.

If ATF comes out through the opening:

it is not necessary to add ATF.

–	Tighten the sealing screw with a new seal, to a torque of 15 Nm. This concludes the ATF test.

If ATF does not come out through the opening:

–	oil must be topped up. → Chapter

SEAT Workshop Service and Repair Manuals