–
| Rotate the multi-function switch -A- until the connector tab -arrow 1- inserts into the groove on the gauge -T10173 -. |
If the connector tab can not be inserted into the groove of the adjustment gauge, the gearbox may not go into the position „N“. In this case, the gearbox must be put into the „N“ position using the adjustment gauge: |
–
| For this rotate the adjustment gauge forwards or backwards until the connector tab -arrow 1- inserts into the groove of the gauge -T10173- (if necessary, rotate the multi-function switch -A- a little). |
–
| Secure the gauge -T10173- with the grip (knurled) bolt -C- on the selection shaft. |
–
| Tighten the bolts -B- to a torque of 5.5 Nm. |
–
| Remove the gauge from the selection shaft. |
Installation is done in the reverse order. |
|
|
|