Leon Mk1
| Assembly overview |
| Dismantling and assembling procedure → Chapter |
| 1) | Adjustment work is required if these components are renewed, adjustment overview → Chapter. |
| 1 - | Sealing cap |
| q | Will be destroyed during removal. |
| q | Always renewing. |
| 2 - | Circlip |
| q | Always renewing. |
| 3 - | Drive flange |
| q | Pulling out together with output shaft → Item → Anchor. |
| q | Pressing off → Fig.. |
| q | Pressing on → Fig.. |
| 4 - | Output shaft for drive flange |
| q | Pulling out of rear axle housing with drive flange → Item. |
| q | Pressing drive flange off and on → Fig. and → Fig.. |
| q | Installation position → Fig.. |
| 5 - | Drive flange oil seal |
| q | Levering out with lever. |
| q | Driving in flush drift sleeve -3158-. |
| 6 - | Cover → Note |
| q | Removing → Anchor. |
| q | Pressing in → Anchor. |
| 7 - | Shim S1 |
| q | Noting thickness. |
| q | Adjustment overview → Chapter. |
| 8 - | Large taper roller bearing outer race → Note |
| q | Pulling out → Anchor. |
| q | Pressing in → Anchor. |
| 9 - | Large taper roller bearing inner race → Note |
| q | Pressing off → Anchor. |
| q | Pressing on → Anchor. |
| 10 - | Bevel gear with stub shaft → Note |
| q | Bevel gear with stub shaft is matched with shaft bevel gear. |
| q | Allocating according to gearbox code letters with parts catalogue → Chapter → Electronic parts catalogue “ETKA”. |
| 11 - | Small taper roller bearing inner race → Note |
| q | Pressing off → Anchor. |
| q | Pressing on → Anchor. |
| 12 - | Small taper roller bearing outer race → Note |
| q | Driving out → Anchor. |
| q | Pressing in → Anchor. |
| 13 - | Shim S2 |
| q | Noting thickness. |
| q | Adjustment overview → Chapter. |
| 14 - | Rear axle housing → Note |
