Leon Mk1
Dismantling and assembling procedure |
Special tools and workshop equipment required |
t | Pressure plate -VW 401- |
t | Pressure plate -VW 402- |
t | Press tool -VW 407- |
t | Press tool -VW 409- |
t | Press tool -VW 412- |
t | Pressure piece -VW 432- |
t | Thrust pad -VW 447 i- |
t | Pressure piece -VW 454- |
t | Removal and installation -VW 459/1- |
t | Drift -VW 460/2- |
t | Thrust pieces for pinion shaft bearing -VW 470- |
t | Pressure piece -VW 472/1- |
t | Thrust pad -VW 512- |
t | Hub cap puller -VW 637/2- |
t | Pressure piece -2050- |
t | Drift -3138- |
t | Fitting appliance -3253/1- |
t | Tube -3296- |
|
|
|
|
|
Spline width | Installation position | Identification |
a = 29.0 mm | to drive flange | |
b = 24.5 mm | to differential bevel gear | splines on both sides of groove |
|