Leon Mk1
|
1 - | Bearing housing |
2 - | Reverse gear |
q | With support for reverse shaft |
q | Exploded view - reverse gear wheel → Fig. |
3 - | Bolt, 30 Nm |
q | 3 off |
4 - | Selector fork for reverse gear |
5 - | Pin with clip |
q | For securing reverse gear selector fork to selector rod |
6 - | Reverse gear locking collar |
q | Mark position in relation to synchronising hub prior to removing |
q | Installation position: Taper faces reverse gear synchro-ring |
7 - | Synchronizer body for the reverse gear |
q | Installation position: High inside collar faces 3rd gear wheel. |
8 - | Synchro-ring for reverse gear |
q | Check for wear → Fig. |
9 - | Reverse gear mobile pinion |
q | Insert spring before installing → Fig. |
q | Check axial clearance after installing using feeler gauge (0.20 ... 0.50 mm) |
10 - | Needle bearing |
q | For reverse gear |
11 - | Drive pinion (secondary shaft) |
q | With tapered roller bearing and selector gears for 1st and 2nd gears |
q | Dismantling and assembling → Chapter. |
12 - | Input shaft: |
q | Dismantling and assembling → Chapter. |
|