SEAT Workshop Service and Repair Manuals > Leon Mk1 > 6-speed manual gearbox 02Q, front-wheel drive | Clutch, control | Clutch: Repairing (in conjunction with a dual mass flywheel)

Clutch identification

A clutch manufactured by either „Sachs“ or „LuK“ may be installed.

If the gearbox is installed, the following procedure described must be carried out:

–	Remove central noise insulation -Fasteners 1 ... 3-.

There are a couple of notches -arrows- between the engine-A- and the gearbox -B- under the engine oil sump.

–	Check outer contour of flywheel through these notches.

–	In addition, in some engines a small cover plate -A- can be removed to enable inspection of flywheel's outer contour.

Round outer contour -arrows- = Sachs clutch = -A-

–	Removing and installing the Sachs clutch → Chapter

–	Repairing Sachs clutch → Chapter.

Outer contour with edges -arrows 1- and, in addition, a circumferential crease -arrow 2- = LuK clutch = -B-

Rounded outer contour -arrows 1- and a circumferential crease -arrow 2- = LuK clutch = -B-

–	Removing and installing the LuK clutch → Chapter

–	Repairing LuK clutch → Chapter.

SEAT Workshop Service and Repair Manuals