seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch, control|Clutch > < Safety measures for vehicles with start/stop system

Leon Mk1

Installing
Installing
Installation is carried out in the reverse order, noting the following:
  Note
t  Renew self-locking nuts.
t  Allocate all components according to → Electronic parts catalogue „ETKA“.
–  Insert over-centre spring in mounting bracket from above.
   
–  Receptacle -arrow- for tip -A- of clutch pedal must be vertical.
–  Insert tip of clutch pedal in bearing recess of over-centre spring.
–  Depress clutch pedal slightly, push bolt through and tighten self-locking nut.
  N30-0421
Some cars have damping -arrow- on the mounting bracket/clutch pedal.
–  Return it to installation position.
  N30-10195
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
  N34-11204
–  Fit universal joint -2- to steering box and screw in new bolt -1- → Running gear, axles, steering; Rep. gr.48.
–  Perform basic setting of steering angle sender -G85- using vehicle diagnostic system -VAS 505X-.
Vehicles with knee airbag
–  Install knee airbag → Interior equipment; Rep. gr.69.
Continuation for all vehicles
–  Install trim and cover below trim on drive side → General body repairs, interior; Rep. gr.68.
  N48-10004

Clutch, control|Clutch > < Safety measures for vehicles with start/stop system