Leon Mk1
Note
|
1 - | Conical hexagon bolt |
q | Removing and installing → Item>>>>>>>> |
2 - | Gearbox selector lever |
q | Can be renewed with the selector mechanism installed |
q | Installation position → Fig. |
q | Installing → Fig. |
q | After installing, adjust selector mechanism → Chapter |
3 - | Runner |
q | Clip into relay lever → Item |
4 - | Wiring clip |
q | For relay lever with hole in bearing shaft |
5 - | Return lever |
q | Installation position → Fig. |
q | After installing, adjust selector mechanism → Chapter |
q | Removing and installing → Chapter>>>>>>>> |
6 - | Selector unit |
q | Consists of selector shaft and selector shaft cover |
q | Components cannot be separated from each other |
q | Can be removed and installed with gearbox installed |
q | Selector shaft in conjunction with modified mounting of reverse gear selector fork → Item |
q | Allocation of selector shafts → Fig. |
7 - | Mounting bush |
q | For selector shaft |
q | Removing and installing → Item>>>>>>>> |
8 - | O ring |
q | Insert in peripheral groove of selector mechanism cover |
q | Lubricate with gear oil before installing |
q | Always renew |
9 - | Cap |
q | For gearbox breather |
10 - | Seal for selector shaft |
q | replace → Chapter |
|
Number of selector fingers on selector shaft | Reverse gear selector fork mounting |
2 selector fingers -arrow 1- and -arrow 2- | On the shaft for the reverse gear prong → Fig. |
1 selector finger -arrow 3- | On selector rod with selector fork for 5th and 6th gears → Fig. |