–
| Unscrew the screw -arrow- of the left hand side flange shaft. For this purpose, screw in two screws into the flange and counterhold the flange shaft with an assembly lever. An attachment plug -T10107A- can also be used, in order to adjust the screw to be resolved. |
–
| Remove the flanged shaft with the compression spring, thrust washer and conic ring. |
Installation is carried out in reverse order, noting the following: |
–
| Press the flange shaft against the spring force and tighten to the respective tightening torque. |
Note The gear oil must be renewed; the correct gear oil level cannot be achieved otherwise. |
|
|
|