–
| Unscrew the screw of the right hand side flange shaft. For this purpose, screw in two screws into the flange and counterhold the flange shaft with an assembly lever. An attachment plug -T10107A- can also be used, in order to adjust the screw to be resolved. |
–
| Remove the flanged shaft with the compression spring, thrust washer and conic ring. |
Installation is carried out in reverse order, noting the following: |
–
| Press the flange shaft against the spring force and tighten to the respective tightening torque. |
Note The gear oil must be renewed; the correct gear oil level cannot be achieved otherwise. |
|
|
|