SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Conversion table by relevance >
< Seal for the left hand side flanged shaft: replace
Leon Mk1
7-speed dual clutch gearbox 0AM
Final drive, differential, differential lock / Flange shaft and seals: Assembly overview
Seal for the right hand side flanged shaft: replace
Seal for the right hand side flanged shaft: replace
Seal for the right hand side flanged shaft: replace
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Thrust blocks -3305-
Operation process
Note
t
Observe rules for cleanliness when working on gearbox
→ Chapter
.
t
Refer to general repair instructions
→ Chapter
.
–
Remove flange shaft (right-side)
→ Chapter
.
–
Pry out oil seal with assembly lever.
–
Fill space between sealing lip and dust cap, halfway, with sealing grease. For correct version, refer to
→ Electronic spare parts catalogue
.
Note
t
Do not drive in thrust piece -3305- as far as stop!
t
The oil seal contacts the stop in the gearbox earlier than thrust piece -3305-.
t
It is therefore not possible to drive in thrust piece -3305- as far as the stop.
–
Drive in new oil seal until seal reaches stop (take care to keep seal straight).
Note
If required, a new dust ring can be pressed onto stub shaft using tube -2010-. Do not use a hammer.
–
Install flange shaft (right-side)
→ Chapter
.
7-speed dual clutch gearbox 0AM
Final drive, differential, differential lock / Flange shaft and seals: Assembly overview
Seal for the right hand side flanged shaft: replace
Conversion table by relevance >
< Seal for the left hand side flanged shaft: replace