seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Selector lever and gear selection mechanism with gear selector cable: removal and installation, from 03.2009 > < Gear selection mechanism, vehicles from 03.2009

Leon Mk1

Gear selection mechanism, vehicles from 03.2009: Assembly overview
Gear selection mechanism, vehicles from 03.2009: Assembly overview
  WARNING
Before any repair work with the engine running, put the gear selector lever into the „P“ position and apply the handbrake.
Gear selection mechanism, vehicles up to 02.2009 → Chapter
   
1 - Selector lever handle
removing and fitting → Chapter
2 - Selector lever and gear selection mechanism with gear selector cable
q   Operate manual release mechanism → Chapter
q   removing and fitting → Chapter
q   Check and adjust the gear selector cable → Chapter.
q   Do not lubricate the gear selector cable
q   With integrated printed circuit for selector mechanism (selector lever - E313 -), do not touch
q   Incorporates Tiptronic switch -F189- and selector lever lock solenoid -N110 -. These components can be tested in the „Guided Fault Finding“ mode → Vehicle diagnostic tester.
q   The Tiptronic switch -F189- and selector lever lock solenoid -N110- can only be renewed together with the complete selector mechanism unit
3 - Bolt.
q   8 Nm
4 - Hexagon flange nut
q   8 Nm
q   4x
5 - Lever protection box
6 - Locking plate
q   Replace after each removal

   

Selector lever and gear selection mechanism with gear selector cable: removal and installation, from 03.2009 > < Gear selection mechanism, vehicles from 03.2009