Check and adjust the selector lever control cable. |
Adjusting selector lever cable: verification |
–
| From position „P“ and with the button pressed in, pull the selector lever back approximately 5 mm and hold in this position, without engaging „R“. |
–
| Release the selector lever. |
l
| The selector lever should spring back into „P“ position automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
–
| Place the selector lever in position „N“. |
–
| From position „N“ and with the button pressed in, pull the selector lever back approximately 5 mm and hold in this position, without engaging „D“. |
–
| Release the selector lever. |
l
| The selector lever should spring back into „N“ position automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
–
| From position „N“ and with the button pressed in, pull the selector lever forwards approximately 5 mm and hold in this position, without engaging „R“. |
–
| Release the selector lever. |
l
| The selector lever should spring back into „N“ position automatically. |
–
| If this is not the case, adjust selector lever cable → Anchor. |
|
|
|