–
| Replace the seal -1- in the gearbox, if not fitting a new gearbox. |
Continued for all vehicles |
–
| Place support tool -T20138C- and the base - T20145- on the gearbox. |
–
| Fit the previous assembly onto the hydraulic jack -SAT 1040- and place it in installation position. |
–
| Position the gearbox, checking that no cables or pipes are trapped. |
Vehicles with intermediate shaft |
Continued for all vehicles |
–
| Screw in all the bolts that hold the engine to the gearbox. Use new bolts, check tightening torques → Chapter. |
|
|
|