SEAT Workshop Service and Repair Manuals > Leon Mk1 > Automatic gearbox 001 | Automatic gearbox, gears, control

Reverse gear brake: Removing and fitting

Piston -B1- removing

–	Remove the piston from the gearbox casing by levering with a screwdriver in several places.

Place the support plate and springs on the piston -B1-

–	Fit the spring cage into the guide pivots for piston -B1-.

One of the guide pivots -A- of each group is thicker than the others, supporting in this way the spring cage.

Fitting the inner and outer discs

–	Place the support disc -5- on the safety ring -6- that secures the free gear.

–	Fit the outer discs -4- and inner discs -7- onto the gearbox casing

–	Fit the thrust disc -3- onto the last inner disc.

–	Fit the springs of plate -2-in their corresponding positions, so that the large diameters coincide.

–	Fit the safety ring -1- in the groove of the gearbox casing.

SEAT Workshop Service and Repair Manuals