Leon Mk1
Note
|
1 - | Locking bolt |
q | 15 Nm |
q | Always replace the seal → Anchor |
q | Check the ATF level and top up |
2 - | Overflow pipe |
q | Remove to allow the ATF to drain, ATF level: checking and filling; Changing ATF |
3 - | Bolt |
q | 8 Nm |
4 - | Sump |
q | Procedure for assembly, Planet gears: dismantling and assembling |
5 - | Magnet |
q | Fit to the sump filler neck |
6 - | Bolt |
q | 8 Nm |
7 - | ATF strainer |
8 - | Support plate |
q | With solenoid valves: -N88-, -N89-, -N90-, -N91-, -N92- |
9 - | Bolt |
q | M6×35 mm |
q | 8 Nm |
10 - | Bolt |
q | M6×68 mm |
q | 8 Nm |
11 - | Bolt |
q | M6×12 mm |
q | 8 Nm |
12 - | Solenoid -N93- |
13 - | Bolt |
q | M6×75 mm |
q | 8 Nm |
14 - | Disc-shaped washer |
15 - | Sleeve |
16 - | O-ring |
q | Always replace |
17 - | O-ring |
q | Always replace |
18 - | Bolt |
q | 8 Nm |
19 - | Valve assembly |
q | Identification → Anchor |
q | Removing, Planet gears: dismantling and assembling |
20 - | Manual slide |
q | Secure so that it does not come out when removing the slide box |
21 - | O-ring |
q | Always replace |
22 - | Gearbox casing |
23 - | Connector |
q | For the wiring harness |
q | Removing, Planet gears: dismantling and assembling |
q | Engage on fitting to the gearbox casing |
24 - | O-ring |
q | Always replace |
q | For the wiring harness connector |
25 - | Wiring harness |
q | For the solenoid valves |