seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Upper B-pillar trim (3-door vehicles): Removing and installing. > < Upper B-pillar trim (3-door vehicles): Assembly overview

Leon Mk1

B-pillar trim, 3-door vehicles: fitting Loosening and tightening
B-pillar trim, 3-door vehicles: fitting Loosening and tightening
Special tools and workshop equipment required
   
t  Release lever -T20043-
  Note
The sequence of loosening and tightening is described for the right side of the vehicle. Performing the work for the left side are similar.
Releasing
–  Switch ignition OFF.
–  Move front seat forward as far as it will go and fold over the backrest.
  W00-2324
–  Detach B-pillar trim -1- at bottom and remove in direction of -arrow A- with lever -T20043-.
–  Remove downward in direction of -arrow B-.
Securing
–  Secure in reverse order of releasing.
  Note
t  After installation, check that trim is behind beading of door seal.
t  Before fitting the lining check the condition of the clips and replace if necessary.
  E70-10276

Upper B-pillar trim (3-door vehicles): Removing and installing. > < Upper B-pillar trim (3-door vehicles): Assembly overview