SEAT Workshop Service and Repair Manuals > Leon Mk1 > Body | General body repairs, interior | Trim, noise insulation | Strut linings and side linings | Upper B-pillar trim (3-door vehicles): Removing and installing.

Upper B-pillar trim (3-door vehicles): Removing and installing.

Special tools and workshop equipment required

t	Release lever -T20043-

t	Torque wrench kit -SAT 8010-

Removal:

–	Detach B-pillar trim -1- at bottom and remove in direction of -arrow A- with lever -T20043-.

–	Remove downward in direction of -arrow B-.

–	Remove rear bench seat → Chapter.

–	Fold down the rear seat backrest. → Chapter.

–	Remove side trim → Chapter.

–	Remove the passenger side door sill → Chapter.

–	Fold carpeting to side and unscrew screws-2-.and -4-

–	Remove front seatbelt -1- from guide bracket -5-.

–	Remove upper B-pillar trim from front seatbelt -1- .

Installation

Installation is carried out in the reverse order. When installing, note the following:

Note

Before installing the trim check the condition of the clips and replace if necessary.

SEAT Workshop Service and Repair Manuals