seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Right storage bracket, ST model: Removing and installing. > < Right storage bracket, ST model: Assembly overview

Leon Mk1

Left storage bracket, ST models: assembly overview Removing and installing.
   
Left storage bracket, ST models: assembly overview Removing and installing.
Special tools and workshop equipment required
t  Torque wrench kit -SAT 8010-
t  Release lever -T20043-
t  Release lever -U 30800-

Removal:
–  Remove the rear tray.
   
–  Lift bench seat-1- at front and pull forward -arrow-.
–  Fold down the rear seat back.
  Note
Depending on the work to be executed, the safety belt does not need to be removed. For better representation of the screw -4-, the safety belt is removed in the figure.
  E72-10044
–  Unscrew the bolt of the rear belt fitting sideways → Item.
–  Remove the 12-volt socket -2- → Cigarette lighter, 12-volt socket ; Rep. gr.96
–  Unscrew the bolts -1, 3 and 4-.
–  Detach the trim -5- using the lever -U30800- or lever -T20043- from the attachment of the clips and from the anchoring in the upper C-pillar and D-pillar -arrow- using the lever -T20043- and remove the lining.
Installation
Installation is carried out in the reverse order. When installing, note the following:
  Note
t  Before fitting the lining check the condition of the clips and replace if necessary.
t  Tightening torque → Chapter
  E70-10217

Right storage bracket, ST model: Removing and installing. > < Right storage bracket, ST model: Assembly overview