SEAT Workshop Service and Repair Manuals > Leon Mk1 > Body | General body repairs, interior | Trim, noise insulation | Strut linings and side linings | Partition, bottom, commercial vehicles: Removing and installing.

Partition, bottom, commercial vehicles: Removing and installing.

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-

t	Partition, bottom, commercial vehicles: Removing → Anchor

t	Partition, bottom, commercial vehicles: Fitting → Anchor

Partition, bottom, commercial vehicles: Removing

l	The removal of the partition at the bottom requires the assistance of a second operator.

l	For removing the partition at the bottom, the partition at the top must be removed first → Anchor.

–	Move the front seat to the foremost position and over the backrest.

–	With the support of a second colleague in the cargo area, counterhold the fixing nuts -1-.

–	Loosen and remove connecting bolts -2- between upper dividing wall -4- and reinforcement flange -3-.

–	Carefully remove the partition at the bottom -4- through one of the vehicle doors.

Note

To remove the partition at the bottom -4-, the lower brackets -3- do not have to be removed.

–	Remove bottom mounts, if necessary → Anchor.

Partition, bottom, commercial vehicles: Fitting

Installation is carried out in the reverse order. When installing, note the following:

Note

Once the bottom brackets have been removed, they have to be reinstalled according to → Anchor.

SEAT Workshop Service and Repair Manuals