SEAT Workshop Service and Repair Manuals > Leon Mk1 > Body | General body repairs, interior | Trim, noise insulation | Strut linings and side linings | Partition, top, commercial vehicles: Removing and installing.

Partition, top, commercial vehicles: Removing and installing.

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-

t	Partition, top, commercial vehicles: Removing → Anchor

t	Partition, top, commercial vehicles: Fitting → Anchor

Partition, top, commercial vehicles: Removing

l	When removing the partition at the top, the brackets of the shelves must have been previously removed → Chapter.

l	The removal of the partition at the top requires the assistance of a second operator.

–	Open the tailgate.

–	Remove rear shelf and folding storage.

–	Move the front seat to the foremost position and over the backrest.

–	With the help of a second operator situated in the loading area, hold the securing nuts -4- of the upper -1- and lower partition panel -5-.

–	Undo the connecting screws -2- between the partition at the top -1- and the reinforcement flange -3- and screw them out.

–	With the support of a second colleague in the cargo area, hold the partition at the top -1- and the fixing nuts -4- tight.

–	Loosen and remove connecting bolts -3- between upper dividing wall -1- and reinforcement flange -2-.

–	Carefully remove the partition at the top through one of the vehicle doors.

l	For removing the partition at the top, the upper brackets do not have to be removed .

–	If required, remove the upper bracket for fixing to the bodywork → Anchor.

Partition, top, commercial vehicles: Fitting

Installation is carried out in the reverse order. When installing, note the following:

Note

Once the upper brackets have been removed, they have to be reinstalled according to → Anchor.

SEAT Workshop Service and Repair Manuals